2/22/2016 - Drywall Installation Done affordably
Posted in Unspecified

 

Installing drywall panels must be created by no less than two people. Why? The key reason is because they weight too much and is awkward to utilize in certain spaces. The 4x8 size weighs 55 lbs even though the 4x12 size weighs 82 lbs. The 8ft panels can be carried inside your pick-up truck however the bigger sizes needs to be shipped to your home with something larger.

Ottawa drywall
 

Listed below are the essential tools and materials that you will want for installation:

Tools

 Saw Horse
 Tape Measure
 Utility Knife
 Spiral Saw

Materials

 Drywall
 Drywall Screws
 Joint Compound

All you have to do is always to follow these simple and super easy steps to set up your drywall panels.

Ottawa gypsum taping

1. Be sure you bought enough drywall panels before you start your renovation. Measure your walls as well as your ceiling. Use 3/8" to " thick drywall panel for your walls and 5/8" thick drywall panels to your ceiling.

You can find larger drywall panels you could order when you have a broad ceiling. Drywall panels can be found in approximately 52 ft lengths and 9 feet widths. However, the greater your choice of drywall panel, the heavier they're. Better choose the best size according to your measurements.

2. Install the drywall panels inside the ceiling first before you decide to install the drywall panels to the walls. Locate an assistant that will help you placed the drywall panels in the wall before you decide to nail them.

Maintain 6 inches distance in between each nail. Nails are just secondary fasteners. The drywall screws are the primary fasteners. Choose medium size nails and screws to avoid the nails and screws from coming out. Otherwise, this may lead to further problems when you start taping later.

Ottawa drywall taping

Make use of a lift to set up panels inside your ceiling with the aid of your assistant. It is advisable to put in ceiling panels utilizing a lift in order that the panel can be as tight for the ceiling as you can. When you finish installing the panels in the ceiling, start installing the panels in your walls, and around doors and windows.

3. Once you begin installing the wall panels, make sure to continue to keep them tightly pushed from the ceiling panels. The wall panels will help support the ceiling pieces. Remember that installing panels within the wall often requires several specific holes being cut first - like electrical outlets, doors and windows.

For windows, doors, electrical outlets along with other holes you need to cut, measure carefully and draw a design on the panel to point out the location where the hole ought to be. Cut these patterns using the keyhole saw or even the spiral cut-out saw. Utilize the T-square to make sure your pattern and cut is straight. After the holes are cut, start positioning the panels inside the walls. An excellent general guideline the following is to determine twice, cut once.

4. For those who have long walls, use more than one drywall panel. And keep the 6 inches distance from each nail. This helps your drywall stick to the frame firmer. Perform the nailing and screwing from center out.

5. Once you are done installing the panels, prepare the equipment you will need for taping. Taping is the process of polishing and hiding the joints from the drywall installation. You should utilize a drywall flusher and applicator to evenly distribute the mud solution to the corner and flat surfaces following the installation process (strongly suggested).

Share |
Share and enjoy
  • Digg
  • del.icio.us
  • DZone
  • Netvouz
  • NewsVine
  • Reddit
  • Slashdot
  • StumbleUpon
  • Technorati
  • YahooMyWeb