Valuable Tip - the fan attracts in dust, animal dander, and other things about the property and clogs up the condenser restricting the hot air movement and will reduce the overall performance of cooling.

The fresh food section then will get the chilly air from the evaporator enthusiast that blows across the chilly and frosty evaporator. This air is directed down through a modest chute or hole into the refrigerator.

Now that we have learned how the refrigerator gets cold air and the elements that keep the coolness work, lets talk about the defrost cycle. There are 3 areas in the defrost cycle.

one) The defrost timer usually runs and ought to shut down the cooling approach of the refrigerator to defrost the frost and ice formed by the freon pump in by means of the evaporator coils. the timer cycles eight several hours cooling and 20 minutes even though defrosting.
two) The defrost heater is turned on by the defrost timer. This will take away the frost from the evaporator coil.
three) Defrost termination switch (by-metal)  is a thermostat that shut the heater off at selected temperatures (relying on the refrigerator product).

Freon goes by way of the lines and builds up frost more than men and women consider. A frost create up that will not get defrosted by the heaters that the timer trips will lessen the air flow to the clean food part of the refrigerator part.

In order to comprehensive this job you will require the adhering to instruments:

Needle nose pliers

phillip screwdriver

one/4" nut driver

Ohm meter (Voltage Meter)

The very first thing that you require to do , is unplug the fridge from its power supply. The cold handle is a thermostat that regulates the temperature inside of of the refrigerator. Most chilly controls are found fridge not the freezer. Although there are a few that are positioned in the freezer. This is more generally located in older designs of facet by side models. When you have two controls in your refrigerator, the manage that has the off placement is the Cold Management. The other manage operates a damper that enables the airflow from freezer to the refrigerator. Eliminate the handle panel from the wall then you really should be ready to locate the cold control. The cold manage will have two wires that are plugged into it. You will need to have to take away these two wires, and a prolonged capillary sensor.

Be aware: This test is to be done while the cold manage is set to the ON position. Now place each of the Ohm meter sales opportunities onto every of the terminals on the manage. If the control contacts are closed, there will be a zero reading through on a digital voltage meter or on a regular voltage meter the needle will move to the correct. If there is amount 1 studying on the voltage meter if using a digital meter, this implies the manage contacts are open up and the chilly control is likely to need to be changed.

Note: This check is to be performed while the cold manage is set to the OFF place. Now you need to have to put each and every of the Voltage meter sales opportunities on every single of the terminals of the control. Classroom Kitchen area Centers Fascinate Pupils of All Ages, Refrigerator Door Seals, Diagnosis and Restore

Share and enjoy

Post A Comment! :: Send to a Friend!